Table of Contents
Advertisement
To Playback
For the following operation, start ID codes must be written on the tape. (For how to write the start 1D, see
page @.)
During playback or stop mode
to the beginning of the selection being
To locate the selection ahead
played back or the previous selection
"
Each pression moves the tape to the
mull sisi ene ane
a . pang
previous selection in sequence
ql
:
mae
ma
m4
nie
Len
uf
Liat
ut
PGM No.
PGM No.
To designate three selections back
:
,
2
(excluding the selection being played),
To designate five selections ahead, press
press iq four times.
PP five times.
When the designated selections
When the designated selection is
located, playback resumes.
¢ —00 appears when
located, playback resumes.
mas
designating the selection
wea
being played back.
PGM No.
* When ke is pressed in
the pause mode, the unit
:
nters th
use mode at
The display shows — 00 and goes
ri Sanne of the
The display shows 00 and goes
back to the previous display.
designated selection.
back to the previous display.
This may not function when you play back the tape which was recorded with other DAT decks.
Each time you press the COUNTER MODE
On the indicator for the elapsed time of the
button, the counter changes as follows:
selection
The indicator does not appear in the following cases.
Linear counter
* The selection is played back from the middie.
(tape running time)
© The tape is being fast-forwarded or rewound,
On the indicator for the remaining time
* The indicator does not appear immediately after the
deck is set to the playback mode. It will appear about
Elapsed time of the
ie Seconds later
F
.
selection
¢ Depending on the kind of tape, the indicator may differ
slightly from the actual remaining time.
Absolute time
Remaining time to the end
;
of the whole tape
To check the recorded sampling frequency
Press the & PLAY button longer than usual during .
playback. The sampling frequency will appear in the
display window as long as you press the button.
Accuracy of the indicator for the remaining
time
Despending on the kind of tape, the indicated time may
'
A
ae
:
(example: 32 kHz sampling
28
differ slightly from the actual remaining time.
frequency is recorded.)
Advertisement
Table of Contents
