Table of Contents
Advertisement
From the beginning
From part way through
the tape (from the end of
the section you had
recorded before).
-——
To locate the section to be recorded
New tape
You can begin to record just after
setting the tape.
You cannot operate any buttons for
severalseconds while
tb
7 oP
blinks in the display window.
Wound part way
because you had
recorded before.
New tape, but it has
been recorded part way
and rewound completely.
Recorded tape but it has
been rerecorded part
way.
Begin to record after rewinding the
tape to the beginning with the REW
button.
Forward the tape to the end of the
section you have recorded before
by pressing the FF button, The tape
will stop automatically.
Locate the boundary between the
first section and the second by
listening to the sound. Determine
the exact boundary by watching the
linear counter in the display
window.
If you have no idea
where you had recorded
before.
1 Rewind the tape completely.
2 Press the FF button.
The point where the tape stops
automatically is the end of the
section which you have recorded
before. If the tape goes forward to
the end of the tape, it indicates that
the tape has been fully recorded.
The above is necessary to avoid making a blank
section on your tapes. See 'Note on recording"'
(page @) for details.
When you use a new tape for the first time
to
7 a@F appears inthe display window. This
shows that BB letters are being recorded on the
program number in the read-in section. The read-
in section enables you to start recording from the
beginning of the tape exactly as well as to write
and erase the start ID correctly.
21
Advertisement
Table of Contents
