Advertisement
Setting your M60 up as a Range Extender
To pair your devices with M60, follow the steps below.
1
Plug in to power on M60 and place it near your wireless router. Wait for
/
M60's LED indicator to start pulsing orange.
2
Press the WPS button on the router for 3 seconds. Refer to
/
your router's user manual for router behavior.
3
Press the WPS button on your M60 for 3 seconds.
/
The LED indicator should start pulsing white.
4
When M60's LED indicator turns solid white (may take
/
up to 3 minutes), this indicates M60 is connected to your
wireless router.
You have now completed the setup !
You can move your M60 to any location you want for wireless coverage. By default,
your M60 shares the same Wi-Fi Name and password of your wireless router.
WPS may be disabled on certain routers. If the LED indicator does not blink after pressing
the WPS button, try again and press it a little longer. If that still does not work, use
AQUILA PRO AI App for setup instead.
FAQ
Why can't I access the Internet?
Please reset your wireless router, and if it still does not work, please contact your
internet service provider.
What do I do if I forgot my router's login password?
Please reset your wireless router to default settings and set it up again.
How do I restore the router to its factory default settings?
With the router powered on, press the reset button with a paperclip for 1 second
and then release it. The M60 will now be at its factory default settings.
How to Build a Mesh Network with Ethernet Backhaul?
To create a wired Ethernet backhaul connection, simply connect an Ethernet cable
from the LAN port on your Mesh Wi-Fi router to the LAN port on your Mesh Wi-Fi
node. The Status LED will turn solid white once it has finished pairing with your
Mesh Wi-Fi network in a few minutes.
NOTE
M60 Overview
8
1
2
LED status indicators
Router modes
Connected to the Internet and in
Solid white
operation
Pulsing white
WPS in operation
Pulsing orange
Ready for connection or is not set up
Interleaving white/ orange
Firmware updating
Booting up or resetting to factory
Pulsing red
default
Solid red
Powering on
FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) The device may not cause harmful interface, and
(2) this device must accept any interface received,
including interface that may cause undesired
operation.
Technical Support
Having trouble installing your new product? D-Link's website contains the latest user
documentation and software updates for D-Link products. Customers can contact D-Link
Technical Support through our website by choosing the relevant region.
Contact Us
www.dlink.com/en/contact-us
LED On/Off button
1
Internet port
2
Ethernet port
3
RESET button
4
7
Power connector : (12V/2.5A).
5
6
Power button
WPS button
7
3
4 5
6
LED status indicators
8
Extender modes
Connected to an uplink router and with
good wireless signal
Connected to an uplink router but with
weak wireless signal
Cannot connect to an uplink router or is
not set up
Firmware updating
Booting up or resetting to factory default
Powering on
GPL Code Statement
GPL Source Code Support
https://tsd.dlink.com.tw/GPL
United States
Website: http://support.dlink.com
Canada
Website: http://support.dlink.ca/M60
Advertisement
