Makita DTW1001 Instruction Manual page 8

Reversing switch action
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
Changing the impact force
You can change the impact in three steps: hard, medium and soft mode.
This allows a tightening suitable to the work.
Every time the button
You can change the impact force within approximately one minute after releasing the switch trigger.
2
3
4
Fig.7
► 1. Changed in three steps 2. Hard 3. Medium 4. Soft
5. Button
Specifications of each impact force grade
Impact force grade displayed
on panel
Hard
Medium
Soft
is pressed, the number of blows changes in three steps.
1
5
DTW1001 / DTW1002 /
DTW1001XV DTW1002XV
-1
2,200 min (/min)
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
A
Fig.6
► 1. Reversing switch lever
Maximum blows
DTW1004 /
DTW1004XV
-1
2,400 min (/min) 2,200 min
-1
2,000 min (/min)
-1
1,800 min (/min)
8 ENGLISH
1
Application
DTW800 /
DTW800XV
-1
(/min) Tightening when force and speed
are desired.
Tightening when you need good
controlled power.
Tightening when you need fine
adjustment with small diameter
bolt.
B