Something Not Working - Tricity Bendix TM 200 Operating & Installation Instructions Manual

SOMETHING NOT WORKING_
Before contacting your local Tricity Bendix Service Force please carry out the following checks.
SYMPTOM SOLUTION
4
The machine does not work
♦ Check that there is a supply of electricity
♦ Check the plug fuse
♦ Check the door is closed
4
Check the machine is switched on
4
Check the time selector dial is set correctly
4
The clothes are not dry after normal drying time
4
Check you have used the correct temperature setting
♦ Check the vent hose is not blocked (sometimes a
strong wind may cause back pressure)
4
Check the timer has not been set within a cool down
period
♦ The heater cut-out has operated. See below
Heater Cut-Out
This cut-out operates if the airflow is severly restricted.
Before resetting it check:
^ The filter is clean.
^ The air inlets at the back are not blocked.
4 The exhaust venting is clear and not kinked.
4 There are no other restrictions.
To reset the cut-out, press the red button at the back of the
dryer.
If the cut-out continues to operate after checking the above
points you should contact Tricity Bendix Service Force.
If after the above checks there is still a fault, contact your
local Tricity Bendix Service Force Centre.
If the tumble dryer does not function correctly after these checks, contact Tricity Bendix Service Force.
7