Miele PTD 901 Operating Instructions Manual page 64

| |
English 5 Commissioning
Connecting the mains cable
Note: Select the correct cross section and number of wires in the mains cable to suit the on-site voltage and fuse protection.
1
Ø
Remove the front cover.
Ø
Insert the mains cable (1) at the rear of the machine.
Ø
Pull the mains cable (1) out at the front and guide it to the left.
Ø
Strip the wire ends of the mains cable and attach ferrules.
Ø
Connect the mains cable wires (3) according to the connection diagram (} page 64) and close the quick release connectors (2).
Ø
If necessary, connect the bridges (6) according to the connection diagram (7) and press in firmly using a screwdriver.
Ø
Connect the green-yellow wire to the distributor of the earth wires (4).
Ø
Fasten the mains cable to the mounting plate using a cable tie (5) for strain relief.
Establishing equipotential bonding
1
Connection diagram
64
4
2 3
|
12020321/01; 2023-07
1
5
Ø
Connect the warewasher to the on-site equipotential bonding
system.
Ø
Position of the connecting screw (1) see drawing.
|
6 7
Operating instructions