Step Motor - Pioneer QUANTUM INVERTER Series Service & Troubleshooting Manual

3.5. Step Motor Disassembly
Note: Remove the front panel and electrical parts (refer to 3.1. Front Panel Disassembly, 3.2. Electrical
Parts Disassembly) before disassembling step motor.
Procedure
1) Remove the 3 screws, then remove the
horizontal swing motor(above)(see
Fig. 27).
2) Remove the 2 screws, then remove the
horizontal swing motor(below)(see
Fig. 28).
(For some units)
3) Remove 1 screw, then remove the ionizer
generator (see Fig. 28).
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
Indoor Unit Disassembly

Figure 27
Figure 28
32
