Information Inquiry - Pioneer QUANTUM INVERTER Series Service & Troubleshooting Manual

4. Information Inquiry

• To enter information inquiry status, complete the following procedure within ten seconds:
1. Press LED(or DO NOT DISTURB) 3 times.
2. Press SWING(or AIR DIRECTION) 3 times.
• Finish 1 and 2 within 10 seconds, you will hear beeps for two seconds , which means the unit goes into
parameter checking mode.
• Use the LED(or DO NOT DISTURB) and SWING(or AIR DIRECTION) buttons to cycle through information displayed.
• Pressing LED(or DO NOT DISTURB) will display the next code in the sequence. Pressing SWING(or AIR
DIRECTION) will show the previous.
• The following table (p. 10) shows information codes. The screen will display this code for two seconds, then the
information for 25 seconds.
Troubleshooting

9
