Table of Contents
Advertisement
@ BE SURE TO RELEASE THE ARM CLAMP BEFORE
OPERATING THE START/STOP LEVER
@ OPERATE BY MANUAL FUNCTION EXCEPT FOR STANDARD
SIZE (17, 25, 30 cm), (7", 10", 12")
The stylus set-down point
of this set is adjusted for standard
record sizes only.
© DO NOT GRASP OR HOLD THE TONEARM WHILE AUTOMATIC
MECHANISM IS OPERATING
@ NEVER REMOVE THE TURNTABLE PLATTER UNNECCESSARILY
The turntable platter of this set also plays the part of the rotor
of the motor. Never remove the turntable platter unneccessarily.
This results in a deterioration of characteristics caused by at-
tracting dust or iron filings to the magnet rotor
8 MAINTENANCE
@ WIPE THE DUST COVER WITH ONLY A SOFT, DRY CLOTH
Do not use any cleaner containing alchol, benzine or thinner.
if, for any reason, oil adheres to the dust cover, first discon-
nect the AC power plug or remove the dust cover and wipe the
dust cover with a cloth containing water,
@ APPLY TWO OR THREE DROPS OF OIL TO THE MOTOR SHAFT
Disconnect the AC power plug and remove the turntable platter.
Lubricate two or three drops of oil to the turntable shat.
It is sufficient to lubricate the set once ater approximately 2000
hours of use.
This period is much longer than the ordinary motors, so do not
NOTE
Never use any other type of oil
The bearing parts of this set are designed with an ultra-precise
finish to prevent the generation of
"WOW and FILUTTER"
A special
oil has been used to maintain the high performance
jency of this set by forming a uniform film of oil over the
parts. For this reason, use only the oil included with this set for
its lubrication
9 SPECIFICATIONS
(TURNTABLE SECTION)
Type
...Automatic player system with
MEMO-REPEAT
Driving method
Direct drive
Motor
Ultra low speed brushless OC
motor
'Turntable platter
Aluminium die-cast; 33 em (13")
diameter
250 kg-cm? (86.2 Ib-in?) inertial
moment, 1.75 kg (3.86 Ib) weight
Turntable speeds.
33-1/3 and 45 r.p.m.
'Speed change method ..... Electronic change
Variable pitch controls
......Individual adjustment by variable
resistor, 10% adjustment range
0.03% (W.R.M.S.)
=50 dB (DIN A), 70 d8 (DIN B)
Wow and flutter
Rumble
(GENERAL)
Power supply
120 V, 50/60 Hz
Power consumption
aw
6.5W (While automatic mechanism)
is operating
)
Dimensions
45.3 *36.6 X 13.9 cm (W xD XH)
(17-3/8" * 14-3/8" 5-1/2")
(WxDxH)
Weight
9.4 kg (20.7 Ib)
(Ss
(TONEARM SECTION)
Type
nee
Universal " S "
shaped pipe arm,
static-balanced type, direct read-
ing stylus pressure adjustment, with
anti-skating force contro! device,
cueing device
230 mm (9-1/16")
«15 mm (19/32
Within +3° (at the point 150 mm
(-1/8") from the center)
+1* (at the point 55mm (2-3/16")
from the center)
Effective length
Overhang
Tracking error angle
Offset angle
e e e
to
Adjustable stylus pressure...0-3 g
Cartridge range
45-99
8.5-13 g (with auxiliary weight)
Head shell weight
959
Advertisement
Table of Contents
