Table of Contents
Advertisement
3 HOW TO ASSEMBLE
INSTALLATION OF THE
TURNTABLE PLATTER
Install the turntable platter to the motor shaft.
Place the turntable sheet on the turntable platter.
NOTE
This set is especially designed for a direct drive player system.
Therefore, the rotor, which is rotating part of the motor, is con-
nected directly to the turntable platter. (The magnet of the motor
is attached to the turntable platter),
Connect the lead wires to the cartridge terminals.
White (L +)...Left channel +
Red (R +)... Right channel +
Blue (L -)...Left channel —
Green (R —) Right channel —
'Overhang adjustment
Screw
f
wi
Cartridge
Install the cartridge to the spacer, and tighten it with screws.
Adjust the overhang position so that the spacing between the
stylus tip and the plug is 52 mm (2-1/16").
(See Fig. 2, 3)
Overhang adjustment screw
Plug
—
—
Stylus tip
52 mm (241/16) |
sa
ADJUSTMENT OF THE
HORIZONTAL BALANCE
Release the arm clamp, and turn the balance weight forward or
backward until the tonearm is approximately balanced (stylus
pressure is "O"). (See Fig. 4)
'When horizontally balanced, set the stylus pressure ring to "O
position, pushing gently with fingers, so that the balance weight
is not moved. (See Fig. 5)
Fig. 3
Turn the balance weight forward to set the stylus pressure ring
to the proper stylus pressure of which you use.
NOTE
If the weight of the cartridge is over 8.5g, mount the auxiliary
weight to the rear shaft of the tonearm.
Stylus pressure ring moves to gear with balance weight so that
it is possible to set the stylus pressure ring tothe desired position
by turning the balance weight.
Arm clamp
Rear shaft
Arm pipe
Cueing lever
ADJUSTMENT OF THE
ANTI-SKATING FORCE
Turn this knob to the same number as the stylus pressure.
INSTALLATION OF THE DUST
COVER
Raise the dust cover upward and place it securely in the hinges.
NOTE
(See Fig. 6)
We recommend that you take off the dust cover, if the dust cover
becomes the cause of "HOWLING" from the vibration of the
speakers.
Dust cover
Advertisement
Table of Contents
