Advertisement
o Z
Back Panel Descriptions
1.
Power Supply Plug
Use only the 16-16.5 volt AC 1000 mA adaptor provided. (Peavey part #70900660)
2.
Effect Select Switch
When this switch is in the "out" position, the two 6-way telephone jacks alongside the switch are
used to connect the LICON 416 to extemal effects. When this switch is in the "in" position, all
extemal effects are bypassed.
3.
Effect Output Jacks
Use these 6-way telephone jacks to connect the LICON 416 to any 0-10 volt DC logic controlled
effects unit. (See Pin-out diagram on page 8.)
4.
Sync Out Jack
This 1/4" jack is provided especially for use with the Illuminator 600 lighting system. Simply
connect a 1/4" to 1/4" instrument cable from the Sync Out jack of the LICON 416 to the Sync In
jack of the Illuminator 600. The LICON 416 will now control the Illuminator 600.
5.
Function Pedal Jack
This is for use with the Function Pedal footswitch controller. Peavey part #0007907
6.
Channel Pedal Jack
This is for use with the Channel Pedal footswitch controller. Peavey part #0007862
7.
RCA Audio Input Jacks
These RCA jacks will accept input from any line level audio source. For example, you can use any
of the following audio sources: mixer, stereo, CD player, preamp, karaoke (Protege™ by Peavey),
etc.
8.
RCA Parallel Output Jack
These RCA jacks allow you to pass the line level audio signal present at the audio input to units
like power amplifiers, effects units, equalizers, crossovers, etc.
Connection Ideas
+ Effects Connections
Advertisement
