Advertisement
NUSA
FLASH
里
@
10.
11.
y
F
=
display the currently selected chase pattem.
Hold Button and LED
Pressing and releasing this button holds the current chase pattern. Pressing and releasing this button
again allows the LICON 416 to play each pattem four times and then move to the next pattern. The
LED glows red when in hold.
Blackout Button and LED
Pressing and releasing this button blacks out (turns off) all the lights. The LED glows red when in
blackout. Pressing and releasing this button again de-selects blackout.
All On Button and LED
Pressing and releasing this button tums all the lights on. Pressing and releasing this button again
turns all the lights off. This button will not turn on all the lights when the blackout is active. The 47
On button also works with the Flash button described below.
Flash Button and LED
Pressing the F/ash button is used to flash all the lights on the system. If the 47 On button is off,
pressing the Flash button will cause all the lights to tum on until the Flash button is released.
[f the All On button is on, pressing the Flash button will cause the 47 On feature to be bypassed until
Teleasing the Flash button.
Effect Buttons and LEDs
The Effect buttons perform two functions: 1) If the LICON 416 is in the channel mode (see
Back Panel Descriptions: Effects Select Switch), the Effects buttons will control the channel lights.
2) If the LICON 416 is in the effects mode, the Effects buttons will control extemal effects devices,
such as any 0-10 volt DC logic controlled effects units or relay packs.
Flash Buttons and LEDs
The Flash buttons will flash the lights controlled by the Effects buttons. If the Effect button is off,
pressing the Flash button causes the effect to tum on until the Flash button is released. If the Effect
button is on, pressing the Flash button causes the effect to tum off until the Flash button is released.
Advertisement
