Advertisement
ON
ON
S T A N D B Y P O W E R
ELECTRONICS
PATENT
REMOTE
Provided for the connection of the
supplied remote footswitch. When
the footswitch is plugged into the
remote footswitch jack, the channel
select switch
must be pressed
to the "in" position for remote
selection to operate. Remote
selection of the LEAD or RHYTHM
channel (left footswitch button) or
outboard devices in the effects
loop (right footswitch button) is
possible with the remote footswitch.
RHYTHM
FLOW BLOCK DIAGRAM
JACK
Paralleled
connecting speaker enclosure(s) to
the amplifier (minimum: 4 ohms).
When using more than one
enclosure, be sure to calculate the
total impedance and set the
impedance switch
(See section on IMPEDANCE
SWITCH.)
Important: Use only high quality,
connections.
PRE
SELECT
C R U N C H
BACK PANEL
O U T P U T S
output jacks for
accordingly.
cable for speaker
POST
LOW MID HI
PREAMP
5150 is a Registered Trademark of Edward Van
SELECTOR
Use to select the appropriate
. .
impedance of the speaker
enclosure(s). If two enclosures of
equal impedance are used, the
switch should be set at one half of
that value
16 ohm
enclosures: set switch to 8 ohms;
two 8 ohm enclosures: set switch
to 4 ohms).
FOOTSWITCH
EFFECTS
I
MPEDANCE
SWITCH
RESONANCE
PRESENCE
OUTPUT
Advertisement
