Motor Replacement - Teac A-4010GSL Service Manual

REEL HEIGHT ADJUSTMENT
NOTE: Reel height adjustment is required only if a motor has been
replaced or when the tape rubs excessively against the reel flanges.
Load unit with tape (standardized and start the tape. Adjust by
turning the screw in the reel table until the tape does not rub
against the reel flanges.
REEL TABLE ASSY REPLACEMENT
- Remove reel table by loosing the reel height adjustment screw.
- Reel table will slide off upward.
~ Remove the two allen screws at lower end of brake drum.
- Pull out the brake drum in the direction of the motor shaft.
~ Reverse: the procedure for reassembly.
~ Position the brake drum from the edge of the brake band as shown.
REEL HEIGHT
REEL TABLE ASSY
9339
M-O333
Fig. 3-2 Reel Table Assy Replacement
CAPSTAN MOTOR REPLACEMENT
- Slide out the capstan belt.
- Loosen the two set screws on pulley
and lift off pulley.
- Unsolder the six wires connecting
the capstan motor.
- Reinstall by reversing above
procedure.
- Apply a drop of LOCTITE on the
screws when adjustment
is complete. Fig.
3-3
Capstan Motor Wiring
TAPE SPEED Sw
AC 100V