Table of Contents
Advertisement
7. Lift up tool rest base locking lever (N) Fig. 8, and
loosen tool rest locking lever (0).
8. Reposition too! rest base (P) and tool rest (Q) on lathe
bed as shown in Fig. 9, and tighten locking levers (N) and
(O).
9. Loosen tailstock locking lever (K) Fig. 10, and slide
tailstock (C) onto right end of lathe bed as shown. NOTE:
Make sure clamp (R) is in position underneath lathe bed.
10. Fig. 11, illustrates tailstock (C) mounted on right end
of lathe bed. Tighten locking lever (K).
Advertisement
Table of Contents
