Laser Safety Cautions - Optoma ZU1050 User Manual

‡ Only use attachments/accessories specified by the manufacturer.
‡ Do not look into straight into the projector lens during operation. The bright light may harm your eyes.
‡ This projector will detect the life of the lamp itself.
‡ When switching the projector off, please ensure the cooling cycle has been completed before
disconnecting power. Allow 90 seconds for the projector to cool down.
‡ Turn off and unplug the power plug from the AC outlet before cleaning the product.
‡ Use a soft dry cloth with mild detergent to clean the display housing. Do not use abrasive cleaners,
waxes or solvents to clean the unit.
‡ Disconnect the power plug from AC outlet if the product is not being used for a long period of time.
‡ Do not setup the projector in places where it might be subjected to vibration or shock.
‡ Do not touch the lens with bare hands.
‡ Remove battery/batteries from remote control before storage. If the battery/batteries are left in the
remote for long periods, they may leak.
‡ Do not use or store the projector in places where smoke from oil or cigarettes may be present, as it
can adversely affect the quality of the projector performance.
‡ Please follow the correct projector orientation installation as non standard installation may affect the
projector performance.
‡ Use a power strip and or surge protector. As power outages and brown-outs can KILL devices.

Laser Safety Cautions

This product is classified as CLASS 1 LASER PRODUCT - RISK GROUP 2 of IEC 60825-1:2014 and
also complies with 21 CFR 1040.10 and 1040.11 as a Risk Group 2, LIP (Laser Illuminated Projector) as
defined in IEC 62471:2006 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
‡ This projector has built-in Class 4 laser module. Disassembly or modification is very dangerous and
should never be attempted.
‡ Any operation or adjustment not specifically instructed in the user's guide creates the risk of
hazardous laser radiation exposure.
‡ Do not open or disassemble the projector as this may cause damage by the exposure of laser
radiation.
‡ Do not stare into beam when the projector is on. The bright light may result in permanent eye damage.
‡ When turning on the projector, make sure no one within projection range is looking at the lens.
‡ Without following the control, adjustment or operation procedure may cause damage by the exposure
of laser radiation.
‡ Adequate instructions for the assembly, operation, and maintenance, including clear warnings
concerning precautions to avoid possible exposure to laser.
5
English