ELNA 6003 Instruction Book page 32

¢ Classic Sensor Buttonhole or Stretch Sensor
Buttonhole (cont'd)
© Remove the fabric and place a pin just inside the
bartack at each end to prevent accidentally cutting
bartacks. Cut buttonhole open with the seam ripper.
When buttonhole sewing is finished, push the button-
hole lever upward as far as it will go.
@ Ifthe button is extremely thick and difficult to fit
through the test buttonhole, you can lengthen the
buttonhole by pulling the button holder on the foot
back a little extra. The tength of the hole will increase
by that same amount.
Button holder
Slider
There should be no gap
Spring holder
GBOedo
* How to Alter Buttonhole Stitch Width and Length
The pre-programmed stitch settings are shown on the
screen.
Press the or key to alter the buttonhole
for different weights of fabric and thread.
@ Narrow width
@ Wider width
@ Shorter stitch
® Longer stitch
30