ELNA 6003 Instruction Book page 31

e Classic Sensor Buttonhole or Stretch Sensor
Buttonhole (cont'd)
@ Extend the button holder to the back and place the
button in it. Push the holder together tightly around the
button.
@ Button holder
Pull the buttonhole lever down as far as it will go.
Buttonhole lever
Place both threads to the left under the foot.
Insert the garment under the foot and lower the needle
at the starting point. Then lower the automatic button-
hole foot.
Mark buttonhole placement
Starting point
Press the foot control until the machine completes the
buttonhole and stops by itself
The buttonhole will automatically sew: the front bartack
and left side first, then the right side and back bartack
and stop.
After sewing the classic buttonhole, the machine
message will read "Raise Foot".
To sew another classic buttonhole or to start from the
beginning of the buttonhole, press #9 (BH1) key, then
press the foot control.
e After sewing the stretch buttonhole and the machine
message reads "Completed", simply lift presser foot,
move fabric and begin sewing next buttonhole.