Firehawk FHB10-RF Pairing Manual

Advertisement

Pairing Guide
SMOKE ALARM
HEAT ALARM
FHB10-RF
FHH10-RF
CO ALARM
HEARING IMPAIRED CONTROL UNIT
CO10-RF
FHN800HIA
READ & RETAIN THESE PAIRING INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FHB10-RF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Firehawk FHB10-RF

  • Page 1 Pairing Guide SMOKE ALARM HEAT ALARM FHB10-RF FHH10-RF CO ALARM HEARING IMPAIRED CONTROL UNIT CO10-RF FHN800HIA READ & RETAIN THESE PAIRING INSTRUCTIONS...
  • Page 2 COMPATIBLE ALARMS FireHawk RF-Link devices can be radio linked (wirelessly) to Smoke Alarms (FHB10-RF), Heat Alarms (FHH10-RF), Carbon Monoxide Alarms (CO10-RF), RF-Link equipped Mains Smoke and Heat Alarms (fitted with FHN600RF RF-Link module) and Hearing Impaired Control Units (FHN800HIA). 1. CONNECT 1.1 Plug alarm into pattress and switch on radio base, the pattress led...
  • Page 3 2. ALARM ASSEMBLY 2.0 Bring alarm & radio base together then twist/slide to lock into place. The light will flash RED and the device will beep. 2.1 Repeat this procedure for each additional alarm in the system 3. LINKING 3.1 Press the TEST BUTTON on any assembled alarm, this will put it into linking mode and its light will flash red and green.
  • Page 4 4. LINKED ALARMS READY FOR INSTALLATION 4.1 Press the TEST BUTTON on any one alarm and wait for each linked alarm to sound. (Due to signal timings each alarm may trigger at the same time making it difficult to detect a faulty alarm). Please perform a test from each alarm in the system to ensure every alarm is successfully linked.

This manual is also suitable for:

Fhh10-rfCo10-rfFhn800hia

Table of Contents