Proposition 65; Installation; Unpack The Machine; Add Bar And Chain Oil - GreenWorks CS82210 Operator's Manual

EN
7

PROPOSITION 65

This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
8

INSTALLATION

Do not change or use accessories that are not
recommended by the manufacturer.
Do not install battery pack until you assemble all the
parts.
8.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
• If parts of the machine are damaged, do not use
the machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
WARNING
WARNING
WARNING
WARNING
WARNING
English
5. Discard the box and packing material in
compliance with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
8.2

ADD BAR AND CHAIN OIL

Examine the amount of oil in the machine. If the oil
level is low, add the bar and chain oil as follows.
Use only bar and chain oil.
The machine comes from the factory without bar and
chain oil.
1. Switch off the chainsaw and engage the chain
brake.
2. Remove the battery and position the chainsaw on
a level surface with the oil cap facing upwards.
3. Flip up the tap and turn the oil cap (6) counter-
clockwise to remove.
4. Put the oil into the oil tank.
5. Monitor the oil window (7) to make sure that no
dirt gets into the oil tank while you add the oil.
6. Put the oil cap on.
7. Turn the oil cap clockwise and press the tab down
to close.
8. The whole oil tank will last for approximately 20-
40 minutes.
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
8
WARNING
IMPORTANT
NOTE
IMPORTANT