Page 1
WE SUGGEST NOT TO RETURN THE PRODUCT TO THE STORE QUESTIONS? PROBLEMS? MISSING PARTS? For FAQ, Manuals, Videos Or Spare Parts, Please Visit bestwaycorp.com/support 58623E OWNER’S MANUAL bestwaycorp.com/support Visit Bestway YouTube channel...
OWNER’S MANUAL physical, sensory or mental capabilities, or lack of experience and knowledge, IMPORTANT SAFETY unless they have been given supervision INSTRUCTIONS or instruction concerning use of the appliance by a person responsible for their safety. When installing and using this Children should be supervised to ensure electrical equipment, basic that they do not play with the appliance.
Page 4
other objects into the openings and and charging base with wet hands. moving parts of the robot. • Keep the external adaptor disconnected - DO NOT use this robot to pick up any toxic from power when it is not in use. substance, flammable and combustible •...
accessories. Make sure to charge the - Increase the separation between the robot to about 30% to 50% of the battery equipment and receiver. capacity before it is stored. Store in a - Connect the equipment into an outlet on well-ventilated area away from sunlight, a circuit different from that to which the heat, ignition sources, pool chemicals,...
Page 6
Assembly and Operation WARNING For Charging • Use only the original external adaptor and provided charging cable. • Make sure the robot and the charger port are clean and dry before set-up. • Make sure that the robot is turned off by sliding the switch to OFF position prior to charging. •...
Page 7
Note: If float is too far to be retrieved by hand, use the provided hook. Place the hook on the telescopic pole (not included) and then use the hook to retrieve the float.
Flap replacement Maintenance and Storage 1. Battery discharges on its own during storage. Make sure to fully-charge the robot before storage. 2. You must re-charge the battery at least once every three months when it is not in use. • Unplug the external adaptor from the socket and then unplug the charging cable from the external adaptor and robot. •...
3. Remove the battery pack to expose the PCBA. To detach the battery connection wire, press NOTE: the clip on the connector and then pull it out. Wrap the connector immediately with insulating tape in order to avoid short circuit caused by contact of both wire terminals. TROUBLESHOOTING Problem Possible Cause...
Page 10
Side flap does not come up. Check and remove any debris that hinders the movement of the flap. Detach the swivel head and smoothening-ring in accordance with instructions of section “How to remove the battery pack” from the manual, then: - Remove trapped debris Swivel head bottom is jammed - Verify the smoothening-ring and bottom plate are installed...
Page 12
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia Tel: Australia: (+61) 29 0371 388; New Zealand: 0800 142 101 Exported by/Exporté...
Need help?
Do you have a question about the 58623E and is the answer not in the manual?
Questions and answers