Advertisement
ASSEMBLY INSTRUCTIONS PAGE 4
10
Foot Straps
Raise Seat Platform to chest height.
Use Buckle Straps
Platform Assembly
separate from each other accidentally. (See Buckle Strap Instruc-
tions Below).
11
Thread loose end of strap on Foot Platform through Buckle on Seat
Platform and tighten appropriately.
NOTE: Have straps adjusted with seat frame at chest height
while standing on platform. This will all for ample range of
movement while climbing.
Have both top and bottom platforms angled
down towards base of tree to compensate for a
smaller tree diameter at desired hunting height.
CINCH STRAP INSTRUCTIONS
1
Hold buckle as shown.
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
to join the two sections of stand so Foot
and Seat Platform Assembly
2
Press down on latch and
insert strap underneath
teeth as shown.
BULLET DRIVE ALUMINUM CLIMBER
At ground level, step cautiously onto the Foot Platform Assem-
bly
. Attach your harness to the tree (as per harness
manufacturer's instructions).
10
While standing on the foot platform facing the tree, insert your
feet under the foot straps. Tighten foot straps as needed.
Attach Bungee Strap
feet in foot straps (as shown Left).
At ground level, apply pressure to both platforms
to ensure they have appropriate angle on tree
and Adjustment Knob is properly installed.
11
will not
3
Pull strap to desired
length.
MODEL: PVCS-420
N
around your heels to assist in keeping
4
Pull slack to tighten.
WWW.PRIMALTREESTANDS.COM
©2018 (rev. 3/18)
Advertisement
