Advertisement
ASSEMBLY INSTRUCTIONS PAGE 2
BOTTOM
3
Ladder Lock
Unfold arms on Seat Platform Assembly
3
side up over Seat Pad
the bottom of Seat Platform Assembly
webbing strap through the "Ladder Lock." Pull webbing
firmly to tighten.
5
Bullet Drive System
Notched ends of
cable locking
into slotted
rail tube
Install Foot Platform Assembly
the cable around back of tree and through rail tube
5
"Bullet Drive System" (as shown above).
To tighten, pull on cable allowing "notched" ends to slide
into the locking "slotted" end of rail tube. Pull until the
Foot Platform Assembly
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
, place bottom
and attach Seat Pad
around
by weaving the
onto tree by wrapping
is firmly locked to tree trunk.
BULLET DRIVE ALUMINUM CLIMBER
4
Carefully turn Seat Platform Assembly
4
attached right side up. Attach Arm Rest Covers
to right and left Arm Rests. Attach Shooting Rail Cover
to front shooting rail (as shown Above).
6
Install M10 Quickclip
Platform Assembly
cable in place. Install by sliding Quickclip pin
6
through BOTH attachment holes at the end of
rail tube. Once though, flex and fasten metal
loop onto the end of pin (as shown Above).
NEVER remove this quick clip while this
Climber is in use. If these Quick Clips
missing or not correctly installed, DO NOT
use this climber.
WWW.PRIMALTREESTANDS.COM
MODEL: PVCS-420
TOP
with Seat Pad
into rail tube of Foot
in order to lock notched
©2018 (rev. 3/18)
are
Advertisement
