Advertisement
ASSEMBLY INSTRUCTIONS PAGE 3
7
8
Bullet Drive System
Notched ends of
cable locking
into slotted
rail tube.
Install Seat Platform Assembly
Assembly
8
through rail tube"Bullet Drive System" (as shown above).
To tighten, pull on cable allowing "notched" ends to slide into the
locking "slotted" end of rail tube. Pull until the Seat Platform
Assembly
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
Roto Sleeve
onto tree ABOVE Foot Platform
by wrapping the cable around back of tree and
is firmly locked to tree trunk.
BULLET DRIVE ALUMINUM CLIMBER
Use the "Roto Sleeve" to fine adjust the cable tension
7
on the Foot Platform Assembly
tree trunk becomes more narrow, it may be necessary
to tighten the cable attachment using this "Roto Sleeve".
9
Install M6 Quickclip
Platform Assembly
cable in place. Install by sliding Quickclip pin
9
through BOTH attachment holes at the end of
rail tube. Once though, flex and fasten metal
loop onto the end of pin (as shown Above).
NEVER remove this quick clip while this
Climber is in use. If these Quick Clips
missing or not correctly installed, DO NOT
use this climber.
WWW.PRIMALTREESTANDS.COM
MODEL: PVCS-420
. As you climb and the
into rail tube of Foot
in order to lock notched
are
©2018 (rev. 3/18)
Advertisement
