Table of Contents
Advertisement
Available languages
Available languages
•
The bracket has magnets
made of steel or iron. Common examples of suitable surfaces include steel framing studs, steel
door frames, and structural steel beams.
Using the Lasers with Accessories
The lasers are equipped with a 1/4" x 20 female thread on the bottom of the unit. This thread
is to accommodate current or future D
specified for use with this product. Follow the directions included with the accessory.
CAUTION: The use of any other accessory not recommended for use with this tool could
be hazardous.
If you need any assistance in locating any accessory, please contact D
Co., 701 East Joppa Road, Towson, MD 21286 or call 1–800–4‑D
See our catalog on the World Wide Web at www.D
Maintenance
•
To maintain the accuracy of your work, check the laser often to make sure it is properly
calibrated. See Field Calibration Check.
•
Calibration checks and other maintenance repairs may be performed by D
service centers.
•
When not in use, store the laser in the kit box provided. Do not store your laser at
temperatures below ‑5 ˚F (‑20 ˚C or above 140 ˚F (60 ˚C).
•
Do not store your laser in the kit box if the laser is wet. The laser should be dried first with
a soft dry cloth prior to storage.
Cleaning
Exterior plastic parts may be cleaned with a damp cloth. Although these parts are solvent
resistant, NEVER use solvents. Use a soft, dry cloth to remove moisture from the tool
before storage.
Troubleshooting
The Laser Does Not Turn On
•
Remove the batteries and replace with fresh batteries. Ensure the battery contacts are
free of corrosion.
12
which allow the unit to be mounted to most upright surfaces
WALT accessories. Only use D
e
WALT accessories
e
e
WALT (1–800–433–9258).
e
WALT.com.
e
English
WALT Industrial Tool
WALT
e
15
Advertisement
Table of Contents
