Low Battery Indication - DeWalt DW0822-XJ Instruction Manual

Cross line and plumb spots laser
Table of Contents

Advertisement

Available languages

Available languages

English
Follow instructions in the Maintenance section of this manual. Use of unauthorized parts
or failure to follow Maintenance instructions may create a risk of electric shock or injury.
Use only accessories that are recommended by the manufacturer for your model. Accessories
that may be suitable for one laser, may create a risk of injury when used on another laser.
Battery
This tool is powered by three 1.5V AA size alkaline (LR6) batteries.
To install batteries (Fig. B)
1. Lift up the battery compartment cover 
2. Insert three fresh AA alkaline (LR6) batteries in the compartment, placing the batteries
according to (+) and (–) on the inside of the battery door.

WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce
this risk:
Use battery operated tool only with the specifically designed batteries. Use of any other
batteries may create a risk of fire.
Carefully follow all instructions and warnings on the battery label and package.
Always insert batteries correctly with regard to polarity (+ and –), marked on the battery
and the equipment.
Do not short battery terminals.
Do not charge batteries.
Do not mix old and new batteries. Replace all of them at the same time with new batteries
of the same brand and type.
Remove dead batteries immediately and dispose of per local codes.
Do not dispose of batteries in fire.
Keep batteries out of reach of children.
Remove batteries if the device will not be used for several months.

Low Battery Indication

The lasers are equipped with indicator lights 
of the on/off buttons  
A flashing indicator lights indicates the batteries are low and need to be replaced. The laser
may continue to operate for a short time while the batteries continue to drain, but the
beam(s) will quickly dim. After fresh batteries are installed and the laser is turned on again,
the laser beam(s) will return to full brightness and the indicator lights will stay off. (A flashing
laser beam is not caused by low batteries; see Out of Tilt Range indicator.)
10
 3 
 4 
 and 
 5 
.
 1 
.
 2 
. The indicator lights are located to the right

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dw0822Dw0822cg

Table of Contents