Frigidaire PCFG3670AF Installation Instructions Manual page 12

36" FULL GAS RANGE INSTALLATION INSTRUCTIONS
Oven cavity burners:
3: Broiler burner
4: Oven burner
Broiler and oven burners power table
Burner
3
No.
Power
14000
(BTU)
Natural gas nozzles table (Pressure in W.C.P.: 5")
Burner
3
No.
Nozzle
165
number
LPG nozzles table (Pressure in W.C.P.: 10")
Burner
3
No.
Nozzle
110
number
Location of the appliance's Gas and
Electric connections
4 Gas connection
5 Electrical connection
Connect the gas supply line to the unit pressure reg-
ulator using a 1/2" flex gas line connector between
the manual shut-off valve and the pressure regula-
tor. A metal flex line or fixed metal pipe must be
used to connect the gas to the appliance. If a metal
gas line cannot be used, consult your local certified
electrician or local electric codes for proper ground-
ing.
Check the supply line connections for leaks using a
soap solution or non-corrosive leak detection fluid.
Do not use a flame of any sort.
WARNING
appliance. After installation, it must be easily
accessible in an emergency.
4
1. Turn on gas.
2. Apply a soap solution or non-corrosive leak
17000
detection fluid to all joints and fittings in the gas
connection between the shut-off valve and the
cooktop. Include gas fittings and joints in the
cooktop if connections may have been disturbed
4
during installation. Bubbles appearing around fit-
tings and connections indicate a leak.
180
3. If you detect a leak, turn off supply line gas shut-
off valve and tighten connections.
4. Retest for leaks by turning the gas supply line
shutoff valve on. When the leak check has been
4
completed (no bubbles appear), the test is com-
plete.
117
5. Wipe off all residues of the soap solution or
detection fluid.
Important Notes for Gas Connection:
• The appliance and its individual gas shutoff valve
must be disconnected from the gas supply piping
system during pressure testing of the system at
test pressures in excess of 1/2 psi (3.5kPa).
• The appliance must be isolated from the gas sup-
ply piping system by turning off its individual man-
ual shut-off valve during pressure testing of the
gas supply piping system at test pressures equal
to or less than 1/2 psi (3.5kPa).
12
Install a gas shutoff valve near the