Table of Contents
Advertisement
The appliance stops during the programme
Check whether:
The "Start/Pause" button,then start the drain process.
The door has been opened and the "Start/Pause" button not be pressed.
Close the door and press the "Start/Pause" button again.
Check if there is too much foam inside, machine enters kill-foam routine. The
machine will run again automatically after a period.
The washing machine's safety system has been actived (see "Fault
description table").
Residue from detergent and additives left in the detergent drawer at end of
wash.
Check whether:
The cover grid of the softener chamber and the separator of the main wash
chamber are correctly installed in the detergent dispenser and all parts are
Clean (see "Care And Maintenance").
Sufficient water is entering. The mesh filters of the water supply could be
Blocked (see "Care And Maintenance").
The position of the separator in the main wash chamber is adapted to the
use of powder or liquid detergent (see "Detergent and Additives").
Machine vibrates during spin cycle.
Check whether:
The washing machine is level and standing firmly on all four feet.
Transportation bolts have been removed. Before using the machine, it is imperative
that transportation bolts are removed.
Final spin results are poor.
The washing machine has an imbalance detection and correction system. If individual
heavy items are loaded (e.g. bathrobes), this system may reduce the spin speed
automatically or even interrupt the spin completely if it detects too great an imbalance
even after several spin starts, in order to protect the washing machine.
26
Advertisement
Table of Contents
