Pool Maintenance - Intex 159631NP Manual

(300) EN16927 INFLATABLE POOLS AND PLAY CENTER ITEMS 4.875" X 6.5" 10/14/2019
ENGLISH
8. Depending on the type/model of the inflatable pool, slowly fill with water:
a. just below the horizontal line indicator printed on the inside of the pool's wall, or
b. just below the over-flow holes indicator on the inside of the pool's wall, or
c. just below the first top air chamber ring.
a.
NOTE: Some pools feature over-flow holes midway along the wall. This is to prevent overfilling the pool beyond the recommended
water depth. There are no plugs, do not cover the over-flow holes.
All drawings for illustration purpose only. May not reflect actual product. Not to scale.
INSTRUCTIONS FOR PRODUCTS WITH WATER SPRAYER AND OTHER ACCESSORIES (VARY FROM MODELS):
Attaching the water sprayer
1. Locate the sprayer connector (A).
2. Attached the sprayer connector (A) to a garden hose (B) by threading the sprayer coupling onto the garden hose. Tighten
securely.
3. Turn the water on slowly at first to allow water to gradually fill in. Then adjust the spray as desired.
4. If an adaptor is provided (vary with models), thread the adaptor (C) to the sprayer connector (A) and insert the garden hose (B)
into the adaptor (C).
Attaching the arch or canopy
1. Place the inflated arch or canopy over the top surface of the inflated pool wall.
2. Make sure the arch base or canopy pillars are securely attached to the top surface of the inflated pool wall.

Pool maintenance

• Inspect the pool at the beginning of each use for holes, leakage, wear and tear and other damages. Never use a damaged pool.
• If applicable, check pins, bolts and screws for rust; splinters or any sharp edges regularly, especially accessible surfaces, to
avoid injuries.
How to drain your pool, winterizing and long term storage:
1. Adults shall drain and store the pool. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Remove all accessories, toys, garden hose, etc from the pool.
3. Open the drain valve cap (vary from models).
4. Carefully open the inflation valve caps and/or exhaust valve caps to deflate the air chambers, and slowly push the sidewall
inward and down to speed up the drainage of the pool. Slowly lift one side of the pool to drain out the remaining standing water.
5. Re-insert all valve caps afterwards for storage.
6. Be sure pool and all parts are completely dry before folding, let it sit under the sun for an hour.
7. Fold and store the liner and accessories in a dry, clean indoor storage location. The original packing carton can be used for storage.
Repair patch:
A repair patch has been included with the product to repair small leak and holes. Refer to the instructions on the back of the repair
patch.
For the following model number: 58431, 56441, 57482, 58480, 57471, 57489, 56494, 57181, 56495, 56493, 58485, 56483,
57495, 58484, 56475, 57192, 57198, 57190, 56490, 57494, 57478, 58469, 57191, 57182, 57183, 57199.
b.
SAVE THESE INSTRUCTIONS
Page 3
c.
300