Starting, Modifying And Ending The Bios Setup Program - Toshiba Portege M400 User Manual

Starting, Modifying and Ending the BIOS Setup Program

Starting the BIOS Setup Program
1. Switch on your computer while pressing the Esc key.
If
Enter key.
Please refer to Chapter 6, the
about the User Password.
The "
displayed.
2. Press the F1 key.
The BIOS setup program will start up.
Modifying the BIOS
1. Select the RAID ARRAY setting in the SYSTEM SETUP (3/3) screen.
Please refer to the operating instructions displayed in the settings screen.
2. The settings are explained as follows. Modify the settings as necessary.
Current State
Create State
Built-in HDD
Second HDD
Configuration status and settings
JBOD
1RAID-0
2RAID-0
RAID-1
UNKNOWN
No Drive
User's Manual
Password = is displayed, enter the User Password and press the
Check system. Then press [F1] key.
TOSHIBA Password
Shows the current hard disk status.
Modify the hard disk configuration. (Modifications
are made with this setting).
Status of the connected hard disk.
Status of the second hard disk.
No RAID settings. Windows cannot be installed
in this disk except for using recovery CD/DVD.
Including RAID settings. Windows can be
installed in this disk.
Set to RAID-0 for 2 hard disks. This cannot be
set in this computer (Current State Only).
Set to RAID-1 for 2 hard disks (Current State
Only).
A RAID status except for the above status and
settings (Current State Only).
No hard disks connected (Current State Only).
TOSHIBA RAID
Utility, for details
" message is
D-4