Table of Contents
Advertisement
CLD-1010
Mechanical Adjustments
@ Measuring equipment
and tools
@ Measurement point
®@ Test disc and set
@ Adjustment point
Stopper
2mm
or fess
Insertion Method
1. Pull the Clamper holder forward until it locks. (The
Loading mechanism comes farther forward than the :
out position.)
. Set the Carrier horizontal and insert it keeping the left
and right guide grooves lined up with the Rollers on
the sides of the Loading mechanism.
. Install the two Plastic rivets.
. Install the Front panel.
: Verification
1. Switch on the power, have the Carrier unload, mount |
a CD or LD disc, then check that the player can play
this disc properly.
. Next, mount the other type of Disc (LD or CD), switch
off the power while the CD motor is swinging, then
check that the clearance between the right rear section
of the Carrier and the Stopper is at least 2 mm, as
shown in the figure above.
85
Advertisement
Table of Contents
