Table of Contents
Advertisement
CLD-1010
® Measuring equipment
and tools
@ Measurement
point
@ Test disc and set
e@ Adjustment point
Polyslider washer
«ss Grease application point
After installing the Intermediate
rack, slide it forward making sure
that the gears mesh properly.
22
SH]
Pinion (E)
Fig. 2
After assembly, move the Intermediate rack all the way to
the left and make sure that the position of the Gear hole (E)
comes to the position shown below.
<= Move the rack.
Hole
Gear (E)
Fig. 3 Verifying the Gear Meshing
Fig. 1 Gear Assembly Gear Teeth Meshing
shown in Figures 1 and 2, install the Intermediate rack :
on the Roller plate (R) assembly.
. Move the Intermediate rack all the way from the po- }
sition it has been fitted into and make sure that the :
hole in the Gear (E) is in the position shown in Fig. 3. :
When carrying out Operations 1-4 above, grease the
locations shown in Fig. 1.
:
B83
Advertisement
Table of Contents
