How To Use As A Dry Iron-8; Special Functions-8-10 - Panasonic NI-WL600 Operating Instructions Manual

See section 11 HOW TO CONTROL TEMPERATURE 11 and the following charts:
Temperature Level
—
Steam/Dry Selector Position
LOW
MED
HIGH
c^>
5. Hold the iron horizontally and move the Steam/Dry Selector into the desired steam position
after the Temperature Control light turns on continuously. You can then start ironing.
Note:
Anti-Drip System will activate when the temperature of the Soleplate's surface
drops. At the same time, the steam will stop; it is not a sign of malfunction when
you hear a clicking sound. In this situation, you have to put your iron back on
the Power Base to reheat.
HOW TO USE AS A DRY IRON
1. Move the Steam/Dry Selector to the Dry position.
2. Plug the cord into a standard 120V-60Hz electrical outlet.
3. Set the iron on the Power Base securely. The green 11 OFF11 light will turn on.
NOTE: If the green light does not turn on, replace the iron on the Power Base again, or
the Temperature Control Pad cannot function.
4. Push the11 SET11 Pad until the red blinking light reaches your desired temperature level.
Wait until the Temperature Control light turns on continuously. You can then start ironing.
SPECIAL FUNCTIONS
1. Jet of Steam
The11 Jet of Steam" feature provides extra stear
is helpful for removing stubborn wrinkles. The11 Ji
only in the 11 HIGH11 indication area of the "SET" F
n which goes deep into the garment and
Bt of Steam11 feature operates properly
>ad when steam or dry ironing (If used
ethe iron is not hot enough to change
Bf Steam 11 feature for a long time, it is
sing this feature on any clothes to be
sveral times away from the ironing board
spotting or water spotting on the clothes.
at lower setting, water spotting will occur becaus
water to steam ). If you have not used the 11 Jet <
necessary to clean the inside of the iron before u
ironed. Simply test the "Jet of Steam" feature se
and clothes to be ironed. This will prevent brown
AWARNING
Do not aim the soleplate toward hands
or body while steam ejects. Exposure
to steam can cause skin burns.
1. Fill iron with water. See section " HOW TO FILL WITH WATER ".
2. Plug the cord into a standard 120V- 60Hz electrical outlet.
3. Set the iron on the Power Base securely. The green M OFF" light will turn on.
4. Push the " SET" Pad to the " HIGH" temperature level. The red light starts blinking.
5. Preheat the iron until the light turns on continuously, usually about 1-2 minutes.
6. Simply pump the" Jet of Steam Button " when steam is desired. Pump the" Jet of Steam
Button " several times at the beginning of each ironing session.
7. Allow at least 5 seconds between uses of "Jet of Steam Button 11 to prevent water spotting.
Use a press cloth if necessary.
-
8
-