Advertisement
© Level Meters
These indicate the level of the output signals. When
"O"
of the Level
Meter
is lit, the output
level is
—10dBm
from the pin jack, and from the standard
phone jack is +4dBm with the Output Level Selector
set to "+4", and —10dBm when it is set to "—10".
@ Pilot Lamp
When the mixer is turned on, this lamp lights up.
@ Power Switch
This turns on or off the mixer. When
it is turned on,
the Pilot Lamp lights up.
* Turn on or off the mixer with the Master Faders set
to zero
@ Effect 1 Return Knob
This knob controls the mixing level of the signal returned
to the Effect 1 Return Jacks (L,R) form the external
effect (delay, reverb, etc). Clockwise rotation increases
the level. Effect 1 Send/Return Jacks, this knob controls
the overall volume of the reverb sounds while the Effect
1 Send Knob controls the reverb level of each channel.
® Effect 2 Return Knob
This knob controls the mixing level of the signal returned
to the Effect 2 Return Jacks (L,R) from the external
effect (delay, reverb, etc). Clockwise rotation increases
the level.
@ Headphone Jack
Connect stereo headphone to this jack.
@ Headphone Level Knob
This knob controls the volume of the headphone sounds.
Rotating this clockwise increases the volume.
* The Headphone
Level circuits are completely in-
dependent from the Master Fader, therefore you
can monitor sounds through headphones even the
Master Fader is set to zero.
@ Master Faders (L, R)
These sliders control the overall volume of the mixed
signals separately for left and right. Raising the slider
will increase the volume and lowering it decrease. The
optimum level with the lowest noise and distortion is
where the red indicators of the Level Meters light
occasionally.
@ Input Jacks
These are input jacks for connecting to a mixing device
such as microphone,
electronic musical instrument,
tape deck or CD.
@ Effect 1 Send Jack
This is an output jack for connecting the input jack of
an external effect unit (delay, reverb, etc). Through
this jack, the signal which has been level-adjusted at
the Effect 1 Send Knob of each channel is sent out.
Advertisement
