Advertisement
@ Overload Indicators
sensitivity.
.
* The Overload Indicators light up when the level of
the signal is 6dB lower than the clipping level (=the
level where the sound starts being distorted).
@ Gain Knobs
© Treble Knobs
@ Bass Knob
@ Effect | Send Knobs
to the Effect 1 Send/Return Jacks, rotating this knob
clockwise will deepen the reverb effect.
* The output from the Effect 1 Send is post fader,
and therefore changes depending on the positions
of the Gain, Treble, Bass and Channel Fader Knobs.
@ Effect 2 Send Knobs
These knobs control the level of the signals to be sent
to the Effect 2 Send Jack. Clockwise rotation increases
the level. For instance, when a reverb unit is connected
to the Effect 2 Send/Return Jacks, rotating this knob
clockwise will deepen the reverb effect.
* The output from the Effect 2 Send is post fader,
and therefore changes depending on the positions
of the Gain, Treble, Bass and Channel Fader Knobs.
@ Panpot Knobs
Each
Panpot Knob routes the input signal from an
input Channel to the left and/or right mixing busses.
By means of the Panpot Knobs, input signals can be
sent exclusively to one mixing bus, or the other, to
both mixing busses equally or since the Panpot Knob
is Continuously variable to both mixing busses in any
relative proportion desired.
© Channel Faders
This adjusts the level of the signal sent from each
channel. Raising the slider will increase the level, and
lowering it will decrease. 7 to 8 position may be ideal
for the lowest noise and distortion.
Advertisement
