Advertisement
programmed for Monday, 1 will appear.
action is scheduled, either
C48, OFF or j§ ah and
G7 & is being displayed.
NOTE
The temperatures mentioned above are
m=—
for clarifying purposes only, temperature
=
values on your controller may vary.
If 1 does not appear, it indicates that there are no
programmed actions for Monday,
Press the » button again to go to the next day of
the week.
JE will blink, this indicates
that the
programmed actions for Tuesday are being browsed.
The process described above Is now restarted.
If at least 1 action is programmed for Tuesday, 1 will
appear. The clock indicates the time when
the
programmed action will be enabled, either C42,
OFF or /& 8" and 32 & is being displayed.
If 1 does not appear, it indicates that there are no
programmed actions for Tuesday.
Press the co) button to display the next programmed
action. If a second action is programmed for Tuesday,
TE will still be blinking and 1 2 will appear.
Assuming
that 5 actions
were
programmed
for
Tuesday, a total of 5 presses will be required to
display all programmed actions.
lf the first programmed action for today is already
active, the current status of your installation depends,
most probably but not necessarily, on the parameters
Programmed in the first programmed action for today.
Read the important note below.
NOTE
To keep the operation of your installation
m=
simple, the schedule timer settings can
Py
easily be overruled by altering the current
setting
("last
command"
overrules
Previous command until next scheduled
command).
Conclusion: Although
©
is displayed, somebody
might
have
altered
the
settings.
The
next
programmed action will overrule the altered settings
and all settings return as programmed.
9
Remote controller
3P107422-3D
Hide quick links:
Advertisement
