Pioneer VSX-95 Operating Instructions Manual page 22

FRONT PANEL FACILITIES
DISPLAY SECTION
STATION
REAR FRONT | FRONT REAR
err CEnTan mor INBUT
Ase — TONE — TREBLE Ax.
@® Level/Tone meters
The level meter is usually displayed. If the input level is too high, the
display switches, and the OVER LOAD indicator lights.
During Tone control operation, the display switches accordingly.
Character display/Balance meter
® Character display indicates such information as function, received
frequency, station name, acoustic memory, and enhancer memory, .
etc.
© Front and rear left/right balance is indicated. This is displayed during
balance adjustment, after which indications return to character
display.
Top is front.
Bottom is rear.
© DSSS indicator
Lights when the DSSS button is ON.
@ DIRECT indicator
This lights when the Direct mode is switched ON.
© TAPE 2 indicator
Lights when the TAPE 2 MONITOR button is in the ON position.
©) SURROUND MODE indicators
These display the selected surround mode. When all indicators are out,
surround is OFF.
© Meter mode indicator
Indicates the display modes mentioned in @.
@ SPEAKERS indicators
Shows which speaker system (or systems} are switched ON.
@ INPUT ATT indicator
This lights when the INPUT ATT button is switched ON.
22
<ARB1333>
4 my me eres)
om
cons) Cy Sree
Ben toas) (rearen
ra (STEREG] « + CENTER Mone + Canoe]
wens, WIdE NORMAL
Care CES]
REC se.
@ REC selector indicators
¢ The recording source selected with the REC SELECTOR button is
usually displayed.
@® Station call no./Delay time/Surround effect/Enhancer level display
e Usually, the STATION indicator and ''ch'' light to display the station
call number.
¢ When adjusting surround delay time, the DELAY indicator and ms
light to display delay time.
¢ When adjusting surround effect level, the EFFECT indicator lights,
and effect level from 5 to 100 is displayed.
@ When adjusting enhancer level, enhancer level from — 50 to 50 is
displayed.
@ Tuning indicators
FM MONO: This lights when you select MONO with the AUTO/MONO
button. When this indicator is lit, reception of FM stereo
broadcasts is also monaural.
STEREO: When the FM MONO indicator is out (auto stereo mode),
this lights when receiving an FM stereo broadcast.
TUNED: Lights when a station is tuned.
@ CENTER MODE indicators
These display the center mode (NORMAL, WIDE, PHANTOM) during
THEATER, DOLBY PRO LOGIC SURROUND or DOLBY 3CH LOGIC
operation.
Warning indication:
Display section indicators will flash to indicate that operation is not
possible in a particular situation when you press a button. With Multi-
Room & Source, the button itself flashes.