Toshiba RD-XS55 Quick Reference page 2

Make sure the following accessories are supplied.
Supplied accessories
Remote control ............................................................. 1
Batteries (AAA) ............................................................. 2
Coaxial cable ................................................................ 1
Video/audio cable .......................................................... 1
G-LINK ® cable ............................................................... 1
LAN cable ...................................................................... 1
Power cord .................................................................... 1
OWNER'S MANUAL (INSTALLATION GUIDE) ............. 1
OWNER'S MANUAL (OPERATIONS GUIDE) .............. 1
Preparing the remote control
1
Open the cover.
2
Insert batteries (AAA size).
Make sure to match the + and – on the batteries to
the marks inside the battery compartment.
3
Close the cover.
Point the remote control at the remote sensor and press
the buttons.
Distance: About 7 m (23 ft) from the front of the
remote sensor
Angle: About 30° in each direction of the front of
the remote sensor
30°
30°
Within about 7 m (23 ft)
– 2 –
Connections
1
Connect your cable box to the RF IN
(FROM ANT.) terminal or the INPUT1
jacks on the recorder.
If you use the DSS set top box control function
connect your satellite set top box to the INPUT3 jacks.
If you are not using a cable box,
disconnect the antenna cable from your
TV, and connect it to the RF IN (FROM
ANT.) terminal on the recorder. Then skip
to step 3.)
2
Connect the supplied G-LINK
G-LINK jack on the recorder.
Place the transmitter as close as possible to the signal
sensor of the cable box.
3
Connect the supplied coaxial cable of this
recorder to the RF OUT (TO TV) terminal
on the recorder and your TV.
4
Connect the supplied video/audio cable to
the OUTPUT jacks on the recorder and
your TV.
5
If you record from a VCR, connect it to the
recorder.
The following inputs are available:
Rear: INPUT1 jacks, INPUT3 jacks
Front: INPUT2 jacks (Open the lid on the left corner of
the front panel.)
6
Connect the power cord of the recorder to
a wall outlet.
Make sure that the powered recorder lights the
ON/STANDBY indicator on the front panel.
I
42
,
® cable to the