Table of Contents
Advertisement
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com.tw.
If you experience
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
F# E# or F## E##
code
other than as described
above appears in display
Washer making error
beeps
Washer beeps when
START is touched
Clean Washer LED flashing
at end of wash cycle
(on some models)
44
Possible Causes
System error code.
Door has not been opened and
closed for at least 3 cycles.
Door not closed.
The washer has run 30 wash cycles
and is indicating a reminder to run
the Clean Washer with affresh cycle.
Solution
Touch POWER once to clear the code. Then touch POWER
again to restart washer. If code appears again, call for service.
Unplug washer for 30 seconds, then plug back in.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Close the door completely.
Run the Clean Washer with affresh cycle. If the Clean Washer
with affresh cycle is not turned on, the LED will stop flashing
at the end of a wash cycle after running 3 more regular wash
cycles. After 30 more wash cycles are completed, the Clean
Washer with affresh LED will again flash at the end of a wash
cycle as a reminder.
Advertisement
Table of Contents
