Advertisement
KNOW YOUR KETTLE
A
A.
LID
B
B.
TOUCH PAD
C.
LID PANEL
C
D.
SPOUT
D
E.
WATER FILTER
E
F.
STEAM TUBE
F
G.
STAINLESS STEEL BODY
H.
LID RELEASE
G
I.
VIEWING WINDOW
J.
BODY PANEL
K.
ON/OFF SWITCH
L.
POWERBASE
All illustrations are for representation only, your
model may vary from the illustrations shown.
I
NSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose this product in the usual household garbage at the end of its life cycle. Please hand it over to a collection point for the recycling of
electrical and electronic appliances. The symbol on the product, the instruction of use or the packaging will inform you about the methods of disposal.
The materials are recyclable as mentioned on its marking. By recycling, material recycling or other forms of re-utilization of old appliances you are
making an important contribution to protect our environment. Please enquire at the community administration for the authorised disposal location.
SETTING UP
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED.
1
POSITION
2
CORD TIDY
Place the kettle as close to the wall socket as
Use the shortest cord possible. Wrap excess
possible. When in use ensure the kettle is not
cord round the cord tidy on the base of the
placed under kitchen cabinets. DO NOT
kettle.
STORE OR USE YOUR KETTLE IN
AN APPLIANCE GARAGE OR UNDER
CUPBOARDS.
4
NOT IN A TRAY
5
WATER FILTER
Do not operate in a tray.
Ensure water filter is in place. DO NOT
OPERATE KETTLE UNLESS THE
WATER FILTER IS CORRECTLY IN
POSITION.
H
I
J
K
L
In the interest of improving products, Dualit Ltd. reserves the
right to change the product specification without prior notice.
3
INCLINED PLANE
Do not operate on an inclined plane.
DON'T FORGET TO
REGISTER YOUR KETTLE
WWW.DUALIT.COM/REGISTER
OR BY POST
FILLING YOUR KETTLE
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED.
1
OPEN LID
2
Ensure the kettle is unplugged. Remove the
Fill the kettle through the lid opening. Use at least
kettle from the power base. Pull the knob up
one cup of water (250ml). The water level must
and towards the handle to open the lid. The lid is
stay below the 'max' mark. Save energy, only boil
hinged for easy opening and closing.
what you require. Keep kettle upright and level at
WARNING: IF THE KETTLE HAS JUST
all times when filling (maximum 15
BOILED, THE LID WILL BE HOT. USE
not tilt kettle backwards. DO NOT OVERFILL
THE KNOB TO CLOSE THE LID.
OR FILL THROUGH THE SPOUT.
BOILING WATER
WARNING: IF THE KETTLE HAS JUST BOILED, IT WILL BE FULL OF STEAM, WHICH WILL ESCAPE AS SOON AS
THE LID IS OPENED.
1
TURN ON
2
TURN OFF
Plug the kettle into the power socket. Press the
The kettle will automatically turn off after the
'On/Off' switch down. The power neon will
water has boiled and the neon light will go out.
illuminate and the kettle will start to heat up.
To turn off before the water has boiled lift the
If the kettle is accidentally switched on with no
'On/Off' switch up.
water inside, the boil-dry device will switch off the
Always unplug the kettle after each use.
heating element to prevent damage to the kettle.
CLEANING & CARE
Any other servicing should be performed by authorized service representative.
1
THE BODY
2
WATER FILTER
Unplug and let the kettle cool down completely
Unplug and let the kettle cool. Open the lid.
before cleaning. Remove the kettle from the
Hold the top of the filter, pull up and out of
power base.
the kettle. Rinse under a tap while carefully
Wipe the outside and inside surfaces of the
brushing it with a soft brush. Rinse the kettle
kettle with a damp cloth. Ensure that all
out with fresh water. To replace, align the filter
connectors and sockets are kept dry. Do not
with the grooves in the filter holder, insert and
immerse the kettle or power base in water or
push back into place. DO NOT OPERATE
any other liquid. Do not use harsh or abrasive
KETTLE UNLESS THE WATER FILTER
cleaners or solvents.
IS CORRECTLY IN POSITION.
FILLING
3
STEAM
TUBE
CAUTION when
filling to ensure
water does not go
down steam tube,
o
incline). Do
preventing the
kettle from correct
operation.
3
POURING
Remove kettle from the power base. When filling
or carrying the kettle, do not tilt it backwards, as this
may allow water to pass through the steam tube
onto the control area. Should this happen, the kettle
must be allowed to dry before re-using. To avoid the
risk of splashing, once the kettle has boiled wait 10
seconds then pour slowly. Do not over-tilt the kettle.
3
DESCALE REGULARLY
Use descaling products suitable for kitchen
appliances, these are readily available online or
from most supermarkets or department stores.
Use as per instructions on the packet.
Follow these few simple steps to minimise
scale build up in your kettle: Empty the kettle
after each use; do not allow water to stand in
the kettle overnight. Use filtered water instead
of tap water. Descale the kettle regularly, at
least once a month. If you live in a hard water
area you may need to descale more often.
When descaling has finished, empty the kettle
and rinse it out a minimum of 3 times with
fresh water, then refill with fresh water, boil,
then discard boiled water.
TO DO SO CAN CAUSE INJURY.
DO NOT BOIL KETTLE WITH
DESCALING SOLUTION IN IT.
3
CLOSE
LID
Push the lid down
using the knob to
close. Check that it is
fully in place, otherwise
the kettle may not
switch off when boiling.
FAILURE
Advertisement
