Table of Contents
Advertisement
Periodic maintenance and adjustment
3.
Tighten the quick fastener screws.
4.
Place the windshield stay rubber covers
in their original position.
5.
Pass the brake hose, throttle cable, park-
ing brake cable and wire harness through
the cable guide, place the cable guide in
the original position, and then install the
screws.
6.
Connect the auxiliary DC jack coupler.
7.
Install the left side cover and the shroud.
ECS00372
NOTICE
Make sure that all cables, hoses and
●
leads are routed properly before install-
ing the shroud and covers.
When installing the shroud and covers,
●
be sure to tighten the fasteners secure-
ly.
ESU13962
Opening and closing the
shroud and removing and in-
stalling the right side cover
(RST90)
EWS00810
WARNING
Be sure the shroud and right side cover
are secured before operation. A loose
shroud or cover could move and cause
loss of control.
66
Shroud
To open the shroud
Unhook the shroud latches, and then slowly
raise the shroud forward until it stops.
2
1. Shroud latch
2. Shroud
To close the shroud
Slowly lower the shroud to its original position,
and then hook the shroud latches.
Right side cover
To remove the right side cover
1.
Open the shroud. (See the above proce-
dure.)
2.
Remove the screws and bolts, and then
remove the right side cover.
3
1
1. Screw
2. Bolt
3. Right side cover
1
2
1
Advertisement
Table of Contents
