Table of Contents
Advertisement
Control functions
ESU13740
Main switch
The main switch controls the ignition and
lighting systems. The various positions are
described below.
1
1. Off
2. On
3. Start
Off
The ignition circuit is switched off.
The key can be removed only in this position.
On
The ignition circuit is switched on.
Start
The starting circuit is switched on.
The starter motor cranks the engine.
NOTICE: Release the switch immediately
after the engine starts.
TIP
RS90P / RS90PLT / RST90PGT: The
●
headlights and taillight come on after the
engine is started.
RST90: The headlights, meter lighting, and
●
taillights come on after the engine is start-
ed.
ESU10301
Starter (choke) lever (RST90)
Use the starter (choke) lever when starting
and warming up a cold engine.
12
2
3
[ECS00021]
1. Starter (choke) lever
TIP
Refer to the "Starting the engine" section on
page 47 for proper operation.
1. When starting a cold engine.
2. Warming up
3. When the engine is warm.
ESU10312
Throttle lever
Once the engine is running cleanly, squeez-
ing the throttle lever will increase the engine
speed and cause engagement of the drive
train. Regulate the speed of the snowmobile
by varying the throttle position. Because the
throttle is spring-loaded, the snowmobile will
decelerate, and the engine will return to idle
when it is released.
Advertisement
Table of Contents
