Table of Contents
Advertisement
7. Install the server system cover and connect the power cords. See your server system
documentation for instructions.
Configuring the RAID Controller
To configure the RAID Controller, follow these steps:
1. Turn on the system power and check to make sure that the SAS/SATA devices
power up before or at the same time as the system.
2. During the boot, the following BIOS message appears to state the keys that you
need to press to enter the Intel
Press <CTRL><G> to run BIOS Console 2.
This message times out after several seconds. If you miss it, you need to restart
the system.
After you press the keys to enter the Intel
firmware takes several seconds to initialize and then display the Intel
Controller number and firmware version. The numbering of the RAID controller
follows the PCI slot scanning order used by the server board.
3. See the Quick Start User's Guide and the Software User's Guide for instructions to
configure the RAID controller and to install the operating system drivers.
Replacing a Controller
To replace the RAID controller, see your server system documentation for instructions to
remove and then install an add-in adapter.
Resolving a Config Mismatch
If the newly installed RAID controller was previously configured, a message displays
during POST, stating that there is a configuration mismatch because the configuration data
in the NVRAM differs from that in the hard drives. Use these steps to resolve
the mismatch:
1. Press <Ctrl> + <G> when prompted during boot up to access the BIOS
Configuration Utility.
2. Select Configure > View/Add Configuration to see the NVRAM and
drive configurations.
3. If the drives contain the correct configuration, use configuration from the disks.
4. Press <Esc> and select YES to update the NVRAM.
5. Exit and reboot.
Intel® RAID Controller RS25SB008 Hardware User's Guide
®
RAID BIOS Console 2, such as:
®
RAID BIOS Console 2 software, the
®
RAID
9
Advertisement
Table of Contents
