Advertisement
Electronic hidden RFID lock FS
Operating the locks
Shared use mode (all free lockers are unlocked, until user requires storage) (video)
∙
Lock: Hold your user card in front of the door, a long beep
and locking sound confirms successful locking,
close the door to finish.
Personal use mode (all assigned lockers are locked until user requires access)
∙
Unlock: Hold the card in front of
the lock and wait until a single beep is
heard and door opens automatically.
Beeps/ Indications
∙
1 Signal tone and red LED light
Cause: Unauthorized card presented.
(Assigned /Shared Mode)
If an unauthorized transponder is held
in front of the lock 5 times, the lock
blocks for 60 seconds. During the
locking period, the lock rejects all
transponders by emitting a signal
tone and lighting up the red LED.
The locking mode can be cancelled
by holding the manager card in front
of the lock.
Information updated September 2023
∙
Unlock: Hold the card in front of the lock and wait until
a single beep is heard and door opens automatically.
∙
Lock (automatic locking): lock
activates automatically after
5 seconds even in open state.
Door should be closed within
30 seconds.
Note: If the door is not closed during
this time, an alarm sound for
10 seconds (video).
∙
10 second alarm
Cause: Door left open for too long.
(Assigned Mode)
If the lock in Private Mode with
automatic locking (mode 2) is not
closed within 30 seconds after
opening, a 10-second alarm will
sound. This function can be switched
on or off by pressing programming
buttons 1 and 2 simultaneously.
∙
Lock (manual locking): Hold your
user card in front of the door, a long
beep confirms successful locking,
close the door to finish.
∙
8 signal tones and blue LED light
Cause: Battery low (Assigned /
Shared Mode)
If the battery capacity falls below a
certain limit, the blue LED lights up
when a transponder is presented and
a signal tone sounds 8 times. If the
critical range is reached, the lock can
no longer be locked or can only be
opened with the Master Card.
6
Advertisement
