Advertisement
Electronic hidden RFID lock FS
Lock setup
Step 1.
• Assemble the lock and the battery. Use assembly
instructions (link).
Step 2.
• Choose the mode for the lock: Shared use or
Personal use.
• All locks arrive in pre-set as Shared use mode.
No additional programming is required. Skip to Step 3.
Switching from Shared to Personal Use (video).
In order to use the locks in Personal mode you have to
choose out of 2 locking types: automatic locking
or manual locking:
1. To program the locking type, press the programming
button 3 for two seconds.
2. Confirmation of the successful process is flashing of
the green LED and subsequent signal tones:
3. When you hear two signal tones – this is a change
from Shared use to Personal use with Automatic
locking - the door locks automatically after
5 seconds, user card is not required for locking.
4. If you hold further and hear three signal tones – this
is a change from Personal automatic locking to
Personal with Manual locking - user cards must be
presented in front of the door in order to lock
the compartment.
Note:
assigned user cards are deleted when the locking
type is changed.
Information updated September 2023
Step 3
Assigning the cards
• For Shared use mode Master cards need to be
assigned to each lock. User Cards can be used with any
lock that is in shared mode without assignment (video).
• For Personal Use mode both Manager cards and
User cards need to be also assigned to each lock
(video).
Assigning Master card
1. Press the programming button 4 for two seconds.
The green LED starts flashing.
2. While the green LED is flashing, hold the Master Card
to be assigned in front of the lock.
3. A beep confirms the successful operation.
4. If required, hold additional Master Cards to be
assigned in front of the lock one after the other
(max. 3).
A Button 4
5. As the card will/may have the same colour mark this
B Button 3
card to recognize later. (e.g. write "Master card" with
permanent marker on the card and indicate
C Button 2
the location – "1st floor").
D Button 1
E LED
F Battery
compartment
G Hole for
fixing screws
4
A Button 4
B Button 3
C Button 2
D Button 1
E LED
F Battery
compartment
G Hole for
fixing screws
Advertisement
