Advertisement
Important
Safety
Instructions
For Charger
Save these instructions. This manual contains
important safety and operating instructions for
battery charger item nu tuber 9-11040 (981399-001 ).
Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.
Before using battery charger, read all instructions
and cautionary markings in this manual, on battery
charger, and product using battery charger. Follow-
ing this rule will reduce the risk of electric shock, fire,
or serious personal injury.
To reduce the risk of injury, charge only nickel-
cadmium and nickel metal hydride type recharge-
able batteries. Other types of batteries may burst
causing personal injury and damage. Following this
rule will reduce the risk of electric shock, fire, or
serious personal injury,
Do not expose charger to rain or snow. Following
this rule will reduce the risk of electric shock, fire, or
serious personal injury.
Use of an attachment not recommended
or sold by
the battery charger manufacturer may result in a
risk of fire, electric shock, or injury to persons.
Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.
•
To reduce the risk of damage to charger body and
cord, pull by charger plug rather than cord when
disconnecting
charger. Following this rule wilJreduce
the risk of serious personal injury.
•
Make sure cord is located to that it will not be
stepped on, tripped
over, or otherwise
subjected
to
damage or stress, Following this rule will reduce the
risk of serious personal injury.
An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
b. That extension cord is properly wired and in good
electrical condition; and
c. That wire size is large enough forAC ampere rating
of charger as specified below:
Cord Length (Feet)
25"
50"
100"
Cord Size (AWG)
16
16
16
Note: AWG = American Wire Gage
Do not operate charger with a damaged
cord or
plug. If damaged,
have replaced
immediately
by a
qualified
serviceman. Following this rule will reduce
the risk of electric shock, fire, or serious personal
injury.
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman. Following this
rule will reduce the risk of electric shock, fire, or
serious personal injury.
•
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of elec-
tric shock or fire. Following this rule will reduce the
risk of electric shock, fire, or serious personal injury.
•
To reduce the risk of electric shock, unplug
charger from outlet before attempting
any mainte-
nance or cleaning. Turning off controls will not
reduce this risk. Following this rule will reduce the
risk of electric shock, fire, or serious personal injury.
•
Do not use charger outdoors.Following
this rule will
reduce the risk of electric shock, fire, or serious
personal injury.
•
Disconnect charger from power supply when not
in use. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
_kDANGER:
RISK OF ELECTRIC SHOCK. DO NOT
TOUCH UNINSULATED
PORTION OF OUTPUT
CONNECTOR
OR UNINSULATED BATTERY TERMI-
NAL.
•
Save these instructions. Refer to them frequently
and use them to instruct others who may use this
tool. If you loan someone this tool, loan them
these instructions also. Following this rule will
reduce the risk of electric shock, fire, or serious
personal injury.
,_
WARNING:
Some dust created by power sanding,
sawing, grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based
paints,
• crystalline
silica from bricks and cement
and other masonry products, and
• arsenic and chromium
from chemically-
treated lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals:
work in a well
ventilated
area, and work with approved
safety
equipment,
such as those dust masks that are
specially
designed to filter out microscopic
particles.
5
Advertisement
