Advertisement
TO REMOVE
BLADE
See Figure 7.
•
Remove battery pack from saw.
_1, WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
•
Remove blade wrench from storage area. See Figure 1.
•
Position saw as shown in figure 8, depress spindle lock
button, and remove blade screw.
Note: Turn blade screw clockwise to remove.
•
Remove outer blade washer. See Figure 8.
Note: Blade can be removed at this point.
SPINDLE
LOCKBUTTON
TOLOOSEN
\
\
TO TIGHTEN
BLADE
WRENCH
ADE
SCREW
Fig. 7
TO ATTACH
BATTERY
PACK TO TRIM SAW
See Figure 8.
Note: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to page
12, "CHARGING
BATTERY PACK" for charging
instructions.
•
Align raised ribs on battery pack with grooves on
bottom of saw, then attach battery pack to saw as
shown in figure 8.
•
Make sure the latch on battery pack snaps in place
and battery pack is secured to saw before beginning
operation.
LATCH
RAISEDRIBS
/
N
"V//Y/N
BA,,ER, C
? -
_1,
CAUTION:
When attaching battery pack to your
saw, be sure raised ribs and grooves align properly
and latch snaps into place properly. Improper
assembly can cause damage to saw and battery
pack.
11
Advertisement
