7. The first time you
configure the radio, you may
need to populate the
channels. If 'No frequencies'
is indicated on the first line,
click 'Tools' below and 'Load
configuration from receiver'.
See 'Radio Base' section for
more details.
The base and rover must use
the same Channel
frequency, Protocol,
Spacing, FEC setting, and
Format.
If base ID is selected, it must
match Base setup.
Click 'Next'.
8. You can adjust your
satellite cutoff angle here.
Move sliders to use
GLONASS, BEIDOU, and
GALILEO.
Adjust update frequency as
appropriate for your task.
Base and rover need to
match.
Click 'Next' when done.
45
Note:
FCC licensing required for
GNSS radios.