Table of Contents
Advertisement
6.5 Acoustic signals
Acoustic signals sound when a malfunction of
the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default this acoustic signal is deactivated but
it is possible to activate it.
How to activate the acoustic signal for
the end of programme
Make sure the appliance is in user mode.
1. Press
.
• The indicators
are off.
• The indicator
• The display shows the current setting.
–
= the acoustic signal is
deactivated.
–
= the acoustic signal is
activated.
2. Press
to change the setting.
3. Press on/off to confirm the setting.
6.6 AirDry
AirDry improves the drying results with less
energy consumption. The appliance door
opens automatically during the drying phase
and remains ajar.
AirDry is automatically activated with all
programmes other than Rinse Hold (if
applicable).
,
,
and
still flashes.
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.
When AirDry opens the door, the display
shows the remaining time of the running
programme.
CAUTION!
Do not try to close the appliance door
within 2 minutes after automatic opening.
This can cause damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running programme
ends.
CAUTION!
If children have access to the appliance,
we advise to deactivate AirDry. The
automatic opening of the door may pose
a danger.
How to deactivate AirDry
Make sure the appliance is in user mode.
1. Press
.
• The indicators
are off.
• The indicator
• The display shows the current setting.
–
= AirDry is deactivated.
–
= AirDry is activated.
2. Press
to change the setting.
3. Press on/off to confirm the setting.
6.7 Factory reset
Factory reset restores the factory defaults.
Before the reset, make sure the appliance is
in user mode.
Press and hold
seconds.
The displays shows _ _ _ for about 5
seconds.
The appliance returns to programme
selection mode.
Factory reset does not reset the cycle
counter.
,
,
and
still flashes.
and
for 5
ENGLISH
13
Advertisement
Table of Contents
