Table of Contents
Advertisement
Programme 1)2)
P9
1)
The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of
dishes and the degree of soil can change the values.
2)
The values for programmes other than ECO are indicative only.
5.2 Information for test institutes
To receive the necessary information for conducting performance tests (e.g. according to:
EN60436 ), send an email to:
info.test@dishwasher-production.com
In your request, include the product number code (PNC) from the rating plate.
For any other questions regarding your dishwasher, refer to the service book provided with
your appliance.
6. SETTINGS
6.1 Programme selection mode and
user mode
When the appliance is in programme
selection mode, you can set a programme
and enter user mode.
You can also view the number of completed
dishwashing cycles.
Settings available in the user mode:
• The level of water softener according to
the water hardness.
• Activation or deactivation of the rinse aid
empty notification.
• The level of rinse aid according to the
required dosage.
• Activation or deactivation of the acoustic
signal for the end of a programme.
• Activation or deactivation of the AirDry.
• Factory reset.
The saved settings remain valid until you
change them again.
How to set the programme selection
mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
10
ENGLISH
Water (l)
11.9
After activation, the appliance is in
programme selection mode by default. If not,
set the programme selection mode the
following way:
Press and hold simultaneously
and
selection mode.
How to enter user mode
Make sure the appliance is in programme
selection mode.
To enter user mode, press and hold
simultaneously
indicators
flash and the display is blank.
6.2 The water softener
The water softener removes minerals from
the water supply, which would have a
negative effect on the washing results and on
the appliance.
The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in your
Energy (kWh)
0.960
until the appliance is in programme
,
Duration (min)
170
and
until the
,
,
and
Advertisement
Table of Contents
